You must save your project of GNS3 and reload it. Sometimes the newly created VMware Network Adapters doesn't appear in the list. Host with LuminisIndia (VMware Network Adapter VMnet2), Host Client with Client (VMware Network Adapter VMnet3). Link the VMware Network Adapters with the Hosts, e.g. Then change the name of these to : R1 (ISP-India), R2(ISP-US), Host1 (), Host2 (Client).Īdd the notes for network addresses and IP addresses which we will use in this topology. Start your GNS3 and create the topology of the network which we will use. Then change the name of VMware Network Adapter VMnet2 to LuminisIndia. Now we have choice of assigning any IP address from the range of 200.200.200.2 - 200.200.200.254, to VMware Network Adapter VMnet2. Here we are choosing 200.200.200.200/24 for the sake of convenience. But we will assign the IP address 200.200.200.1 as a Default gateway, which will, in effect, become the IP address of ISP-India Router. We can see that the IP address assigned by the DHCP is 200.200.200.1/24. In this step, we will see the status of VMware Network Adapter VMnet2. Now, we will change the name of VMWare Network Adapter VMnet3 to Client. Here we are choosing 33.33.33.33/24 for the sake of convenience. Now we have choice of assigning any IP address from the range of 33.33.33.2 - 33.33.33.254, to VMware Network Adapter VMnet3. Here you can see that DHCP has assigned the IP 33.33.33.1/24 to VMware Network Adapter VMnet3.īut we will assign the IP address 33.33.33.1 as a Default gateway, which will, in effect, become the IP address of ISP-US Router. Open Network and Sharing Center from your Windows 7/8/10, etc and you will find the two new VMware Network Adapters. We can see here are the two new Virtual Networks. We will follow Step2 again and create the 2nd Virtual Network VMnet3, assign the subnet 33.33.33.0/24 and also change the DHCP Settings. To set the specific range of IP for the host click on DHCP Settings and specify the range of IP. If we want to assign IP address automatically to our hosts (PCs or VMs or Servers), we can use the DHCP service which is the part of this Virtual Network. You can see that a new Virtual Network has appeared VMnet2 in the Virtual Network Editor and it has a default subnet, e.g., 192.168.228.0 with subnet mask 255.255.255.0. But we will not use the given subnet, instead we will change it to 200.200.200.0/24. Click on Add Network and select the VMnet ( VMnet2) from the drop down list and click on OK. Then click on Change Settings first, so as to allow us creation of Virtual Networks. Start your VMware workstation software and open the Virtual Network Editor through Edit menu of VMware. We will achieve the fully working topology as shown above, by following the steps in this Visual Guide created by: Meena, Sr. For that we need, two routers (ISP-India, ISP-US), two hosts (, Client), and two Virtual Networks: We will create and configure the above topology. The idea is to provide the helping tool to candidates aspiring to practice and obtain their CCIE, CCNP, CCNA certifications. Two approaches of this integration has been elaborated & presented in this visual guide. The ultimate guide to understand the nuances of integrating GNS3 with VMWare WorkStation version 10/11/12.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |